leveling serew

engine idling speed adjusting screw

发动机怠速调整螺丝

Idle-mixture screw

慢车混合比调整螺丝

Loosen the adjustment screw, and adjust the length of the link rod.

请拧松调整螺丝，拔出或插入连接杆进行调整。

Tighten adjustment screw to 3 N·m (30 in-lbs) torque.

拧紧调整螺丝到3 N·m (30 in-lbs)扭力。

Slide the headlamp bucket downward to disengage it from the headlamp adjusting screws.

向下滑动头灯槽以将其由头灯调整螺丝拆卸。

Remove adjuster lever, adjuster screw and spring.

拆卸调整器杆，调整器螺丝和弹簧。

Loosen setscrew 4.

拧松线张力杆固定螺丝4进行调整。

Lubricate adjuster screw threads and pivot with spray lube.

使用喷雾润滑油润滑调整器螺丝螺纹和枢轴。

Remove screws attaching the adjuster to the grille opening reinforcement (GOR).

拆卸用以固定调整器至格栅口加固板的螺丝。

Remove the throat plate, loosen hook screw 6 and adjust the hook.

调整旋梭时，请卸下针板，拧松旋梭固定螺丝6，然后进行调整。

After the amount of oil in the hook has been properly adjusted with the oil amount adjustment screw, make the sewing machine run idle for approximately 30 seconds,

用油量调节螺丝调整之后，请进行30秒左右的空运转，

All floor-mounted cabinets are supported on four leveling screws that are adjustable from access in toe base.

所有地面安装式柜体均由4个可调螺丝支撑，由踢脚板开口处调整螺母以调节台面水平。

Cams are fastened on the fixture by screws, and the inside transmission system rotates cams to puch crank arms to change the position of slides.

凸轮固定在旋轮轴上，可以螺丝调整前后，并用以推动滑座之运动。

395 we can adjust the levelness of the machine by means of shim and screw jack.

我们可以利用垫铁和螺丝千斤顶来调整机器的水平度。

To Readjust- Loosen lock nut on the adjusting screw.

重新调节：松开调节螺丝上的锁定螺母。

Tighten the pressure regulator.

请拧紧压脚调节螺丝。

feed regulator thumb screw

进料调节器指拧螺丝

"Bolts,screws & nuts"

"螺栓,螺丝及螺帽"